The Model 605A provides two modes of operation, a fixed mode providing a constant +1 kV or -1 kV output, and a variable mode providing variable control of the output voltage with a one (1) volt resolution over a range of 0 to ±1 kV.The Model 605A features an all-solid-state design for accurate, low-noise operation and is protected against over-current conditions that may be generated by output short circuits to ground.A Digital Enable feature provides a connection for a remote device to turn on and off the high voltage of the instrument. This makes the 605A suitable for automated or computer-controlled systems.
Nhà sản xuất: TREK-USA
Front Panel Voltage Controls
Toggle switch to select either fixed or variable output voltage.
Fixed Voltage Selection
Select either +1 kV or -1 kV using the polarity switch when the mode switch is in the fixed position.
Variable Voltage Selection
Calibrated 10-turn dial.
Three-position toggle switch. In the center position the output terminals are disconnected from the high-voltage supply and a 10 kΩ, 2 W resistor is placed across the output terminals.
Digital Enable Feature
A rear panel BNC providing a connection for remotely turning on and off the high voltage output of the 605A.
Tình trạng: CÓ SẴN HÀNG
Liên hệ để có giá tốt nhất: +84(0) 83 833 1313
Factory set for one of two ranges: 90 to 127 V AC or 180 to 250 V AC, at 48 to 63 Hz (specify when ordering).
84 mm H x 254 mm W x 280 mm D, (3.3" H x 10" W x 11" D).
2 kg (4.4 lb).
Two (2) binding posts.
Standard three-prong line connector.
Less than 10 mV rms (measured using the true rms feature of the
Hewlett Packard Model 34401A digital multimeter).